Beware: Lightning Can Easily Fry Your Studio – Even If Cables Are Buried. What To Do, by Mike Harrison
HOME STUDIO
Lightning Can Easily Fry Your Studio
– Even If Cables Are Buried. What To Do …
July 20, 2016
Editor’s note: Last night, during a blazing lightning storm in our area, we recalled the following article in the VoiceOverXtra archives, written by VO pro Mike Harrison, about protecting equipment from lightning strikes. Today, Mike says the advice still pertains, so we think it’s worth a second look …
By Mike Harrison
Voice Actor
Unless you can afford hiring a licensed electrical
contractor to consult and install whatever is necessary to protect your
precious home studio gear from power surges due to lightning strikes, put your
trust in retail-purchased surge protectors at your own risk.
Several years ago, I was living in a garden apartment
complex with maybe 10 or 12 units per building. All utilities were
underground. That includes electrical power, cable TV and telephone.
Cables for
those services came above ground only in the basement of each building and into
their respective distribution panels, from which feeds to each apartment is
run.
I make a point of mentioning the buried power, cable and phone service only
to illustrate that there are no utility poles along the streets within the
complex for lightning to hit.
MY GEAR SET-UP
In my studio at that time, the power cords for the 13-inch
TV and all of my equipment – the Power Mac G4 and its monitor, plus several
Firewire hard drives and a CD/DVD burner, and my audio gear, which included mic
preamp, Digidesign Digi002 A/D interface and Telos Zephyr ISDN codec.
These were all
plugged into several industrial-grade multiple outlet boxes which, in turn,
were plugged into my APC battery backup/uninterruptible power supply, which
featured some degree of surge protection.
ZAP!
The uninterruptible power supply proved its worth on a
couple of occasions, keeping everything humming along quite nicely when the
power would suddenly go out which, oddly, happened far more often than I’d ever
experienced before.
But there were never any serious issues & until after waking
one morning to find the computer wouldn’t power up. Everything else was just
fine, but no computer.
When I got down on my hands and knees and moved closer
to the computer to investigate, I began to sense the dreadfully familiar odor
of burnt electronics.
I instantly remembered being awakened during the night by
a lightning storm.
Upon opening the computer, nothing out of the ordinary was
visible, so I assumed the toasting took place inside the G4’s power supply.
WHAT HAD HAPPENED?
Using my old Power Mac 6500, I was able to find a rebuilt G4
power supply on eBay and, within a few days, the G4 was up and running again.
The 6500 was able to keep me working, but it was slower going.
With all electrical power underground in the apartment
complex, the lightning obviously hit something a good distance away.
Yet, of
all the units in the entire complex, of all the units in my building, and of
all the equipment power plugged into the same source inside my apartment, the
power surge caused by the lightning strike chose only the power supply inside
my G4 to toast.
STRIKE TWO …
Fast-forward to the summer of 2012. Now living in a condo in
a much nicer community and, as before, all electrical, cable TV and telephone
service is underground; no utility poles with exposed cables or transformers on
the property.
Pretty much the same gear wired in the same way; into those same multi-outlet
boxes plugged into the back/UPS.
One afternoon, as a thunderstorm approached, I turned
everything off and went to the kitchen to make a sandwich.
I don’t even know
what word to use to describe what was truly the absolute loudest crash of
thunder I’d ever heard in my 50+ years. Almost literally heart-stopping. It
sounded as though lightning had struck very close-by. VERY close-by.
WHERE’S MY ISDN?
After things calmed down and the sun began peeking out, I
fired up the studio.
The computer powered up, as did everything else I needed &
except the 13-inch TV. It apparently took a hit and was fried.
Then I noticed the front panel of the Telos Zephyr. The
usual ‘Ready’ status had reverted to ‘inact,’ meaning the connection to the
ISDN network was lost.
Several attempts to reboot didn’t cure it, so I looked at
the rear panel and saw, above the RJ11 phone jack, that the green LED that is
usually on steadily was out.
After describing the scenario to the fine support
staff at Telos, the verdict was that the ISDN card inside the Zephyr had also
taken a hit and was fried. They ruled out the possibility that the fault was
with Verizon’s network because, had it been, the green LED would be flashing.
HOW’D IT HIT?
But, Telos said, this surge did not come down the power
line. Had it done so, the Zephyr’s power supply would’ve taken the hit.
No,
this nasty surge came down the phone line. And this was not the first time
Telos had heard this same scenario.
You might know that residential
telephone cable has four wires, and that only two are required per line. In my
case, one pair is for my landline phone and the other pair is ISDN.
Wherever
the lightning strike occurred, it came down only the ISDN pair and left my
telephone untouched.
BEST PROTECTION: UNPLUG
Telos continued by saying there are some very good power
conditioning products out there, but they are not cheap. Those that are more
affordable for the masses might do pretty well keeping the power on during an
outage, but are seriously lacking in adequate surge protection.
Telos sent me a new ISDN card and, $350 later, the Zephyr
was online again.
Thus, the overwhelming advice for the ultimate studio protection
during electrical storms is to not only shut everything off, but completely
disconnect – unplug – everything, from both AC power, cable (internet) and
phone.
UNPLUGGING DRAWBACK …
One possible slight drawback to this is that – depending on your Internet service provider – disconnecting your cable modem (and router) from
their network and unplugging their power may cause your IP (Internet Protocal) address to change
when reconnected.
Such is the case with my ISP. Security on my website is
achieved by not allowing administrative access to any IP address but my own.
It
took some trial-and-error to learn I have to leave the cable modem and router
powered up and connected to their network to retain the IP address. Those two
pieces are plugged into a separate power strip and then directly into the wall;
not into the back/UPS.
But I disconnect the Ethernet cable from between the
router and computer.
IF STRIKE THREE COMES …
So, if another lightning strike occurs, the only things
that might get toasted are the cable modem (which belongs to my ISP, so I
couldn’t care less) and my router, which is far less expensive to replace than
anything else in the studio.
If you have nothing that would be impacted by your IP address changing, all the better.
Yes. I unplug when storms approach, anytime I’m away from
home and, of course, when hitting the sack for the night. A few extra seconds
is so worth it.
——————-
ABOUT MIKE
Since 1973, Mike Harrison has been engaged professionally in
several fields (radio, corporate communications multimedia production,
advertising) where work was performed in either acoustically-treated rooms with
microphones and/or semi-darkened rooms filled with expensive equipment
featuring pretty, often-blinking multi-colored lights and various knobs,
switches and buttons, and whose innate skill with said equipment, particularly
the fluency and speed with which he operates it, has been aptly described by
the words, “wip, bom, bip, bom, boop.” He also writes pretty darned good copy.

Mike,
OH MY! What a tale. I have a power conditioner and battery backup, but now I’m thinking that unplugging is the best line of defense to save our expensive gear and keep intact.
Thanks for this so much!
Bobbin Beam, Female Voice Talent
HOLY GUACAMOLE!!! Twice?
I must admit I’ve gotten really lazy about unplugging. And here in the NE, we have LOTS of thunderstorms. A good reminder Mike.
Mike,
What a story. Okay, you have me checking my set-up now!
Thanks – great advice!
Linda
Good stuff, Mike! I live in Tampa (the lightning capital of the World) and my electric company provides me with a Zap Cap, which is a device that attaches to the meter and prevents surges from getting into the house. My PC is wireless so no cable or ethernet wires to worry about. Your article reminds me about the risks we face as studio owners that we can forget about.
Good tips, Mike. There’s a storm right now, approaching western England. If it gets near, every plug will be pulled from the back of the Mac because above all I don’t want to lose data: worth far more than my simple hardware!
Once we lived in hilly Wales (all utilities on poles) and a crashing hit on our FM aerial fried a much loved vintage amplifier. My wife still misses the sound of that old Williamson.
With you all the way on this one, Mike. I’ve had a Zephyr fried by a lightning strike. These days, if a storm is on the way, everything goes off-line. Disconnected from power and ISDN. Actually, if the Zephyr is not in use, it’s always disconnected. Since I operate on Wi-Fi in the studio and elsewhere in the house, I can stay online to check emails through the laptop. Respond to clients and get back to work when the coast is clear.
Hey, thank you all for your feedback. Yeah, it’s a great example of “what we don’t know can indeed hurt us.”
No one was more surprised than I: first, at how amazingly selective power surges can be (how they somehow ignore everything except one appliance); and second, a spike coming down the phone line and choosing the more expensive of the devices attached.
I think I sleep better now, after unplugging for the night. 😉